Paper Wheels Slicing Edge Sharpening Systems

Description

Charlie Wheel Slicing Edge Sharpening Systems
New
Wheels will fit a buffer or grinder with a 1/2 inch shaft
(May have to remove guards if the buffer/grinder has them)
Should run at least 3000 rpm but less than 3600 rpms
Wheels are about 7 7/8 inch in diameter and 3/4 inch wide
Included in the package  is a container of goose grease to use on the gritted wheel
a container of white buffing compound to use on the buffing wheel
a small package of silicon carbide included if you need to recondition the wheels
an  instruction sheet that tells how to install the wheels
how to use them, and how to recondition when needed.
also a toll free number to call if there is any need for assistance
from the manufacture.
Package also contains reconditioning instructions
A quick reference instruction set is also included in the package
An 800 phone number is available for technical assistance
Check out the sellers other Forschner/Victorinox products